Skip to main content
Skip table of contents

Setting Up and Connecting Sample Data

CData Virtuality provides sample data stored across two different data sources, MySQL and PostgreSQL. Follow the step-by-step instructions below to connect to the databases and access the sample data. 

  • In SaaS, open the CData Virtuality Web UI.

  • In the on-premise version, start the web browser, go to http://localhost:8080/, and open WEB INTERFACE in the WELCOME screen.

Next, do the following:

  1. In the CData Virtuality Web UI, navigate to the Connections tab, then select Sources. Click on +Connect Sample Data under the Use Sample Data section:

    att_13_for_569475080.png

  2. The Code Editor will open, and the connection settings for MySQL and PostgreSQL will be applied. Once the configuration is complete, a message stating Sample data is connected! will appear:

att_14_for_569475080.png

  1. Click the Start button. If the two data sources, mysql and postgres, appear under the Data Sources category in the Browser on the left-hand side, the connection to the database is complete and the sample data can be used:

att_15_for_569475080.png

  1. To verify the connection to the sample database, check the Sources tab under Connections:

att_6_for_569475080.png

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close